- Advertisement -
- Advertisement -

Designing of thermosetting plastic components for direct screwing


Peer-reviewed papers

Authors: M. Sc. Maximilian Kramer, Prof. Dr.-Ing. Christian Hopmann, M. Sc. Johannes Hillemeyer, Prof. Dr.-Ing. Elmar Moritzer
Direct screwing is a very economically viable joining procedure for thermosetting plastic mouldings. However, users do not yet have at their disposal any guidelines to support them with regard to the configuration of the joint. In order to elaborate initial designing recommendations, investigations were conducted into the influences of the screw and tube geometries. Screws with cutting elements were easy to screw into thermosetting plastic moulding compounds. Moreover, it was possible to achieve screwing results in a reliable process using core hole and outside diameters slightly higher than those for the direct screwing of thermoplastics.
Pages: 107 - 115
Ausgabe 2 (2021) Page 107
Ausgabe 2 (2021) Page 108
Ausgabe 2 (2021) Page 109
Ausgabe 2 (2021) Page 110
Ausgabe 2 (2021) Page 111
Ausgabe 2 (2021) Page 112
Ausgabe 2 (2021) Page 113
Ausgabe 2 (2021) Page 114
Ausgabe 2 (2021) Page 115

This article appeared in issue 2 (2021).

Issue 2 (2021)
Joining Plastics
Issue 2 (2021)
› learn more
An active subscription enables you to download articles or entire issues as PDF-files. If you already are a subscriber, please login. More information about the subscription

More content

- Advertisement -
- Advertisement -
- Advertisement -